Boss Snowrator MAG - User Manual

Questions and Answers

A
arthur70Aug 10, 2025
Why is my Boss Snow Blower attachment not working or moving slowly?
- L
  Lisa SteinAug 10, 2025
  There might be several reasons why your Boss Snow Blower attachment isn't functioning correctly or is moving slowly: * The hydraulic fluid level could be low; refer to your Snowrator MAG Owner's Manual. * If the hydraulic fluid level is low, slow the Snowrator MAG gradually before stopping. * The pressure relief valve, located on the Snowrator MAG traction unit, might be bad; clear or replace it if contaminated. * A cylinder or hose could be bad; check for leaks and tighten any loose connections, replacing damaged components as needed. * The hydraulic couplings may not be properly connected to the vehicle; ensure they are securely attached.
T
tristanwilliamsAug 17, 2025
What to do if oil leaks from the hydraulic cylinders of my Boss Snowrator MAG?
- J
  juanreyesAug 17, 2025
  If you notice oil leaking from the hydraulic cylinders of your Boss Snow Blower, here's what you should do: * Check the hoses for leaks. Tighten any loose connections and replace any damaged components. * If a cylinder is bad, replace it. * If the cylinder rod is pitted, polish it with steel wool. If the pitting is severe, replace the cylinder.
A
Alyssa JosephAug 25, 2025
Why are the hydraulic connections on my Boss Snowrator MAG hard to connect?
- D
  dawnharrisAug 26, 2025
  If you're having trouble connecting the hydraulic connections on your Boss Snow Blower, it might be due to pressure buildup. Here's how to address it: * There may be pressure buildup in the snowthrower circuits; loosen the hydraulic lines on the snowthrower to relieve the pressure. * Alternatively, there may be pressure buildup in the Snowrator MAG valves; wiggle the joysticks on the MAG to relieve the pressure.
M
Misty RitterSep 2, 2025
Why doesn't the Boss Snow Blower attachment follow the ground contour?
- T
  Tony BrownSep 2, 2025
  If the attachment on your Boss Snow Blower isn't following the contour of the ground, make sure the attachment coupler lever is in the float position.