Need help?Do you have a question about the Boston Acoustics GT-42 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Frequency Response | 20Hz - 20kHz |
| THD at Rated Power | <0.05% |
| Signal to Noise Ratio | >90dB |
| Input Sensitivity | 0.25V - 5V |
| Crossover Frequency | 50Hz - 200Hz |
| Signal-to-Noise Ratio | >90dB |
| Bass Boost | 0dB - 12dB @ 45Hz |
Details on the amplifier's key features and capabilities.
Provides detailed technical specifications including power ratings and dimensions.
Explains connection and function of front RCA inputs and remote turn-on.
Details the front input switch function and adjusting front input sensitivity.
Describes how to set and adjust the front channel highpass crossover.
Adjusts the Q-factor for the front channel highpass crossover.
Details rear RCA inputs and the secondary remote input connection.
Covers the rear input switch and lowpass crossover slope/frequency settings.
Explanation of the amplifier's status LED indicators and their meanings.
Information on the subwoofer level control and its port.
Describes the benefit of recessed RCA inputs for tight mounting.
Instructions for removing and reinstalling the amplifier's control cover panel.
Details the design and use of the amplifier's adjustable mounting feet.
Emphasizes the importance of keeping cooling vents clear.
Explains how to link multiple amplifiers together.
Details wire gauge requirements for amplifier connections.
Specifies the type of fuses accepted by the amplifier.
Advises caution when driving mounting screws to avoid hidden hazards.
Recommends disconnecting the negative battery cable before installation.
Stresses the need to check the vehicle's battery and charging system capacity.
Guidance on routing wires to prevent noise interference and damage.
Guidance on selecting an appropriate location for amplifier installation.
Specific advice for mounting the amplifier in seats or trunks.
Information on internal amplifier fuses and recommended inline fusing.
Details the recommended wire gauge for power and ground connections.
Instructions for making secure power (B+) and ground (GND) connections.
Steps for connecting the remote turn-on lead to the amplifier.
Guide on connecting speaker wires to the amplifier outputs.
Instructions for connecting a subwoofer using bridged rear channels.
Advice on choosing appropriate music for system tuning.
Instructions for setting front and rear input sensitivity controls to minimum.
Guidance on setting crossovers to 'OFF' for full-range signal.
Configuring head unit settings and adjusting volume for optimal signal.
Detailed steps for adjusting front input sensitivity for undistorted output.
Procedure for setting front highpass crossover and Q control.
Setting rear channel sensitivity and crossover controls.
Explains setting rear channels for summed mono operation for rear fill.
Instructions for setting the subwoofer level control when not in use.
Configuring the rear input switch for mono subwoofer operation.
Setting head unit and volume levels for subwoofer tuning.
Adjusting rear input sensitivity for optimal subwoofer output.
Setting the rear lowpass crossover and adjusting subwoofer phase.
Wiring diagram for a system with full-range front and rear speakers.
Wiring diagram for a system with full-range front and rear fill speakers.
Wiring diagram for a system with main speakers and a single 2-ohm subwoofer.
Wiring diagram for a system with main speakers and parallel 4-ohm subwoofers.
Troubleshooting steps when amplifier LEDs are off but head unit is on.
Diagnosing issues when amplifier LEDs are lit but no sound from speakers.
Steps to identify and resolve engine noise interference.
Troubleshooting distorted audio output from the amplifier.
Identifying causes for amplifier shutdown due to thermal protection.
Troubleshooting amplifier not powering on with a red LED indicator.
Overview of the limited warranty terms and conditions for US customers.
Information on how to obtain service or support for the amplifier.
To Next Page
