Need help?Do you have a question about the Boston Acoustics GT-50 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Power Output (per channel) | 50 Watts |
| Frequency Response | 20 Hz - 20 kHz |
| Total Harmonic Distortion | 0.03% |
| Input Impedance | 10 kOhms |
| Signal to Noise Ratio | >90dB |
| Bass Boost | 0-12 dB |
| Bass Boost Frequency | 45 Hz |
| RMS Power @ 2 Ohms | 75 Watts x 2 |
| Bridged RMS Power @ 4 Ohms | 150W x 1 |
| Low-Pass Crossover Frequency | 50 Hz - 250 Hz |
| RMS Power @ 4 Ohms | 50W x 2 |
Describes how to connect RCA cables from the head unit to the amplifier's front inputs.
Explains the use of the remote trigger lead for turning the amplifier on and off.
Details how to adjust input sensitivity for optimal signal reception.
Explains the highpass crossover adjustment for front and rear channels.
Describes the "Q" factor adjustment for fine-tuning the crossover point.
Details how to connect RCA cables from the head unit to the amplifier's rear inputs.
Explains the switch that routes rear or front signals to the rear amplifier channels.
Describes how to connect RCA cables for subwoofer output.
Details the subwoofer lowpass crossover slope and frequency adjustments.
Information on the subwoofer level control and its port.
Explains the meaning of the amplifier's status LED indicators.
Recommends using high-quality music tracks for setup.
Instructions to set sensitivity controls to minimum initially.
Guidance on setting crossover controls to bypass mode initially.
Advises setting head unit EQ and volume controls for setup.
How to adjust volume to the maximum undistorted level.
How to configure the mode switch for different subwoofer setups.
To Next Page
