Need help?Do you have a question about the Boston gear 700 Series and is the answer not in the manual?
General| Brand | Boston gear |
|---|---|
| Model | 700 Series |
| Category | Inverter |
| Language | English |
Instructions for installing a quill type input on flanged models.
Instructions for installing a 3-jaw coupling input on flanged models.
Instructions for installing a quick connect coupling input on flanged models.
Oil capacities for single reduction models based on mounting positions.
General guidelines for oil capacity in double reduction models.
Details and diagrams for hollow output shaft options on specific single reduction models.
Diagrams for options and accessories specific to models 732-760.
Illustration of the fan kit accessory for models 732-760.
Diagrams for QC and RF models and their associated accessories.
Diagrams for F710-F738 models and their accessories.
Diagrams for hollow output shaft options on double reduction models.
Diagrams showing parts added to W732-W760 for specific configurations.
Diagrams for hollow output shaft options on specific double reduction models.
Diagrams showing parts added to W713-W752 for specific configurations.
Diagrams for QCW models and available kit parts.
Step-by-step guide for disassembling the output shaft assembly.
Procedure for disassembling the input shaft assembly for models F710-F738.
Steps for reassembling the input shaft, including specific models RF/710-RF/730 and RF/732-RF/760.
Procedures for replacing the worm gear on specific F700 series models.
Guide for reassembling the output shaft into the speed reducer housing.
Steps to disassemble the output shaft for 700, RF700, and QC700 series.
Procedure for disassembling the input shaft for RF/710-RF/730 models.
Steps for reassembling the input shaft, including specific models RF/710-RF/730 and RF/732-RF/760.
Instructions for disassembling and reassembling end caps for RF/732-RF/760 models.
Procedure to replace the entire output assembly for RF/710-RF/726.
Steps for replacing the worm gear on RF/730-RF/760 models.
Steps to disassemble the output shaft for W700, RFW700, QCW700 series.
Procedure for disassembling the intermediate worm shaft for FW713-FW752 models.
Steps to disassemble the input shaft for W700, RFW700, QCW700 series.
Procedure to replace the entire output assembly for FW713-FW726.
Steps for replacing the worm gear on FW730-FW752 models.
Defines options for input shaft configuration and motor mounting.
Defines options for output shaft configuration (solid or hollow).
Specifies available materials for housing and mounting components.
Details available materials and paint finishes for the gearbox.
Lists available base and mounting configurations for the gearbox.
Describes vent options for the gearbox (standard, pressure, Posivent).
Specifies endcap and fan options for specific models.
Lists recommended lubricant types for the gearbox.
Specifies available input oil seal types.
Details NEMA motor frame sizes and corresponding bore/keyway dimensions.
Table listing AC voltage, bore code, and motor part numbers.
Defines input shaft styles for double reduction gearboxes.
Defines output shaft styles for double reduction gearboxes.
Specifies double reduction gearbox types (parallel or right angle shafts).
Lists available bases and mounting configurations for double reduction gearboxes.
Describes vent options for double reduction gearboxes.
Specifies endcap options for double reduction gearboxes.
Lists recommended lubricants for double reduction gearboxes.
Specifies available input oil seal types for double reduction gearboxes.
Details NEMA motor mounting configurations for double reduction gearboxes.
Table listing AC voltage, bore code, and motor part numbers.
To Next Page