Vercise
TM
DBS Charging Handbook
91171709-15 Page 13 of 109
Using the Charging System
3. Secure the Charger over the Stimulator by aligning the Charging Collar, or by pressing the adhesive to the skin over the
Stimulator.
Note: If the Charging Collar moves out of alignment, or if the Adhesive Patch is accidentally located in the wrong place,
the Charger will start beeping again. Realign the Charging Collar, or use a new Adhesive Patch to place the Charger
back into the fully aligned position.
Note: Moving around while charging is acceptable, but be aware that the Charger must stay centered over the Stimulator
for proper charging. Excessive movement may cause the Charger and Stimulator to become misaligned.
4. When the Charger emits a distinct double beep, press the power button to turn off the Charger and check the Stimulator’s
battery with the Remote Control.
5. If the Stimulator is fully charged, remove the Charging Collar or Adhesive Patch from your body.
Note: Do not confuse the end of charge signal (a distinct double beep) with repeated beeping indicating misalignment.
6. Separate the Charger from the Charging Collar or Adhesive Patch.
Set aside the Charging Collar or discard the Adhesive Patch.
7. Return the Charger to the Base Station.
To Next Page
Loading...
Need help?
General
