Vercise
TM
DBS Charging Handbook
Vercise
TM
DBS Charging Handbook
92357527-02 Page 16 of 101
3. Secure the Charger over the Stimulator by aligning the Charging Belt, or by pressing the adhesive to the skin over the
Stimulator.
Note: If the Charging Belt moves out of alignment, or if the Adhesive Patch is accidentally located in the wrong place,
the Charger will start beeping again. Realign the Charging Belt, or use a new Adhesive Patch to place the
Charger back into the fully aligned position.
Note: Moving around while charging is acceptable, but be aware that the Charger must stay centered over the
Stimulator for proper charging. Excessive movement may cause the Charger and Stimulator to become
misaligned.
4. When the Charger emits a distinct double beep, press the power button to turn off the Charger and check the
Stimulator’s battery with the Remote Control.
5. If the Stimulator is fully charged, remove the Charging Belt or Adhesive Patch from your body.
Note: Do not confuse the end of charge signal (a distinct double beep) with repeated beeping indicating
misalignment.
6. Separate the Charger from the Charging Belt or Adhesive Patch.
Set aside the Charging Belt or discard the Adhesive Patch.
7. Return the Charger to the Base Station.
To Next Page
Loading...
Need help?
General
