www.etractorimplements.com 32
OPERATION
e. Severe plug:
Loosen the feed hopper anchor nuts and raise the feed hopper. Remove material from
inside the rotor compartment.
Clean out the discharge area/rotor.
Open the rotor cover and clean out the housing. Be sure to turn the rotor by hand to be
sure there is nothing jammed between the rotor and stationary blades.
Close, install and fold down all components opened to unplug. Tighten fasteners to their
specified torque.
f. Check that everyone is clear of machine before restarting engine.
g. Start the engine, engage the PTO and resume working.
WARING
Machine is shown with guard opened or rotor cover opened for illustrative
purposes only. Do not operate machine with guard opened or cover opened.
Feed Hopper Discharge Hood
Rotor Cover
To Next Page
Loading...