- 3 -
Important Safety Notes - Please Read Before Operating Head
Please read and follow these basic safety instructions:
z READ and UNDERSTAND the instructions and specifications.
z NEVER replace the fuse with that of a different type or rating. See Specification
for correct value/type of fuse.
z ALWAYS avoid placing Flash Head cables where they can be tripped over.
z NEVER place heavy objects on top of the Flash Head cables and avoid running
them over sharp or hot objects.
z NEVER use the equipment with damaged cables. Have them replaced as soon as
possible. NEVER attempt to repair them yourself.
z NEVER use the Flash Heads or Pack in an environment where moisture, water
vapour or inflammable liquids, vapour or materials may come into contact with the
Pack or Flash Heads. The flash output as well as the modelling lamps can cause
ignition of or damage to materials that may come into direct or close contact with
the Flash Heads.
z ALWAYS keep ALL vents in the Heads and Pack clear of obstructions at all times.
z ONLY switch the Pack ‘ON’ AFTER THE FLASH HEAD(s) has/have been
connected.
z ALWAYS ensure that the Flash Head cable connectors are correctly fitted before
use.
z ALWAYS remove the Flash Head protective cap before using.
z ALWAYS turn OFF the Pack, disconnect from the supply, unplug the Flash Head /
Heads and allow them to cool before:
a). Replacing the modelling lamp in Flash Head.
b). Replacing the flash tube in Flash Head.
c). Replacing the fuse in Flash Head or Pack.
d). Attaching or removing any accessories- i.e. cover glass,
reflectors, etc.
To Next Page
Loading...
