Bowers & Wilkins PV1D User Manual

15
ENGLISH
9. Aftercare
The PV1D cabinet surfaces will usually only require
dusting. We recommend you use the cloth supplied
with the product. If you wish to use an aerosol or other
cleaner, apply the cleaner onto the cloth, not directly
onto the product and test a small area rst, as some
cleaning products may damage some of the surfaces.
Avoid products that are abrasive, or contain acid, alkali
or anti-bacterial agents. Do not use cleaning agents
on the drive units. Avoid touching the drive units as
damage may result.
To guard against unwanted or accidental
changes to settings or if they become otherwise
corrupted, there are two methods of recovery.
If you are using SubApp™, the current settings may
be saved into an XML le for later recovery and re-
programming of the PV1D. Alternatively they may be
stored in an additional internal memory area of the
PV1D using the following procedure:
i. With the PV1D in Standby mode (Standby
indicator is red), press and hold the logo on/
standby button until the indicator ashes (after
approximately 5 seconds). The navigation buttons
will also light up. Release the button.
ii. Press and hold the button until the indicator
ashes. Release the button.
iii. Press and hold the button until the indicator
ashes. Release the button.
iv. The indicator will switch to white while the
PV1D settings are stored and switch to red
(normal Standby mode) again when the process
is complete.
Note:Duetomemorylimitations,thisbutton
sequencewillnotsavePresets3-5.Allpreset
informationmaybesavedusingtheXMLle
method.
Restoring saved settings
i. With the PV1D in Standby mode (Standby
indicator is red), press and hold the logo on/
standby button until the indicator ashes (after
approximately 5 seconds). Release the button.
ii. Press and hold the button, again until the
indicator ashes. Release the button.
iii. The indicator will switch to white while the
PV1D settings are restored and switch to red
(normal Standby mode) again when the process
is complete.
Restoring factory default settings
i. With the PV1D in Standby mode (Standby
indicator is red), press and hold the logo on/
standby button until the indicator ashes (after
approximately 5 seconds). Release the button.
ii. Press and hold the button, again until the
indicator ashes. Release the button.
iii. The indicator will switch to white while the PV1D
settings return to their defaults and switch to red
(normal Standby mode) again when the process is
complete.
10. Storing current settings 11. Restoring settings

Bowers & Wilkins PV1D Specifications

General

Impedance	100 Ω
Down-firing	No
Subwoofer type	Active subwoofer
Number of subwoofers	2
Subwoofer sensitivity	100 dB
Subwoofer driver diameter	200 mm
Subwoofer frequency range	6.5 - 570 Hz
Subwoofer crossover frequencies	7.5 - 450 Hz
Subwoofer driver diameter (imperial)	8 \
Line-in	Yes
Power source type	AC
Power consumption (standby)	1 W
Power consumption (typical)	150 W
Display	LED
Material	Aluminium, Kevlar
Product color	Black
Speaker enclosure	Closed

Weight and Dimensions

Subwoofer depth	358 mm
Subwoofer width	342 mm
Subwoofer height	270 mm
Subwoofer weight	18700 g