Bowers XT3 - Page 13

XT3 - Digital (Bluetooth®) and Holematic (Bluetooth®) Digital Bore Gauge
24
INST-58-1 Iss 1 25
Bluetooth
®
USA / Canada Certification
BOWERS
M/N: XTDU( )-BT
BOWERS
M/N: XTPG( )-BT
This device contains
FCC ID: 2AAQS-ISP1807
IC: 11306A-ISP1807
NOTICE
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
CAUTION
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference at his
own expense.
Radio Frequency Radiation Exposure information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance of 20cm between the radiator and your
body.
This transmitter must not be co-located or operating in conjunction with any other antenne or transmitter.
Bluetooth
®
South Korea Certification
R-C-iNs-ISP1807
Class A Equipment (Industrial Use)
Bluetooth
®
Japan Certification
Exemption Clause
Relevant regulation requirements are subject to change. Bowers does not guarantee the accuracy of the
before mentioned information. Directives, technical standards, procedural descriptions and the like may be
interpreted differently by the national authorities. Equally, the national laws and restrictions may vary with
the country. In case of doubt or uncertainty, we recommend that you consult with the authorities or official
certification organizations of the relevant countries. Bowers is exempt from any responsibilities or liabilities
related to regulatory compliance.
Notwithstanding the above, Bowers makes no representations and warranties of any kind related to their
accuracy, correctness, completeness and/or usability for customer applications. No responsibility is assumed for
inaccuracies or incompleteness.