Bowflex Results Series

To Next Page

3/12/24, 9:42 AM

BowFlex Results Series Ellipticals - Button (Key) Test

about:blank

1/4

BowFlex Results Series Ellipticals - Button (Key) Test

"Procedure 3"

Applicable for elliptical models: BXE116, BXE216

Follow these steps to test the buttons on your Results Series Elliptical



1. From the Welcome (or Power Up)screen, hold down the PAUSE/STOP button and Down arrow button together for

3 seconds to enterConsole Setup Mode.

2. The console will displaythe TOTAL HOURS screen.

3. Hold down the PAUSE/STOP button and Down arrow button together for 3 seconds to enter Engineering Mode.

4. Push the Down arrow button until the console displays ENTR KEY TEST.

5. Push the Enter button. The console displays BUTTON TEST.

6. Using the guides below, push the corresponding button in the order provided (references 1 and 2). Continue through

all the buttons.

NOTE: If a failed button is discovered, the console may need to be powered downto exit the button test. 

7. When the button test is complete, the console will display DONE, followed by BUTTON PASS. 

8. Push the PAUSE/STOP button to return to the Welcome screen.

9. Flip the power switch to OFF.



(Reference 1)

ID:12713.1

Need help?

Do you have a question about the Bowflex Results Series and is the answer not in the manual?

Bowflex Results Series Specifications

General