Need help?Do you have a question about the Box-Design Pro-Ject Phono Box E and is the answer not in the manual?
Connect the tone arm signal lead to the input (In) of the phono amplifier.
Connect the output (Out) of the phono amplifier to a line input on your amplifier.
Connect the low voltage plug from the power supply to the Power 18V DC socket.
Addresses no signal on channels, strong hum, and earth loop issues.
General| Gain (MC) | 60dB |
|---|---|
| Type | Phono Preamplifier |
| Input Impedance | 47kohms |
| Gain | MM: 40dB, MC: 60dB |
| Input | RCA |
| Output | RCA |
| Input Impedance (MC) | 100 ohms |
| Frequency Response | 20Hz - 20kHz |
| RIAA accuracy | ±0.5dB |
To Next Page
