Trouble-shooting
Problem Cause Solution
Motor not functioning Bad connection or blown
fuse
Check connection. Re-
place fuse.
After setting
opening and close posi-
tion
motor will not function
Bolts used to secure mo-
tor to rail loose.
Programming error
Tighten nuts.
Reset opening and close
position.
Wall switch working, but
not remote control
Remote control has not
performed self-learn.
Remote control battery
at
Encode garage door
opener in remote control
- see item “Self-learning
remote control”
Replace battery
in remote control
Remote control will only
work at short range
Remote control battery
nearly at
Replace battery
in remote control
Garage door stops be-
fore reaching end
Safety device or wall
switch activated
Remove obstruction
Garage door will respond
to remote control or wall
contact activation
Garage door detects an
internal error and display
blinks during self-test
Disconnect from mains.
Reconnect after 5
seconds. If fault per-
sists, contact Millarco’s
service department
Garage door will not fully
open or close
Programming incorrect
Door damaged
Weather conditions,
e.g. rain or snow have
increased door weight
Reprogram
Contact repair workshop
for repair.
Garage door perceives
situation as an obstruc-
tion. Set power to higher
level.
Remove snow from door
Light will not come on Defective bulb Replace bulb
To Next Page
Loading...
