BOXER 63022 - Remote Control Pairing

17
1. When your garage door opener is connected to your Wi-Fi network, the Wi-Fi
network indicator will turn off and remain off.
2. You can delete the garage door opener from the current Wi-Fi network
connection by pressing and holding the Wi-Fi button until the Wi-Fi indicator
turnsonandstartsashing.ThismeansthatthecurrentWi-Finetwork
connection has been interrupted.
3. You can also delete the garage door opener as a device in the Tuya app on
your smartphone. Select the garage door opener in the Tuya app and tap
“Remove device” to delete connected garage door openers.
Remote controls
Adding and deleting
• Press the CODE button on the control panel once. The display shows “7”.
Press the remote control button you want to program twice. The display
showsaashing“7”.Thismeansthattheremotecontrolhasbeenadded
correctly. (The remote controls supplied are already added upon delivery and
require no additional pairing.)
• Each remote control can operate up to 2 garage door openers if a control
button is added to each motor unit.
To delete a remote control from a garage door opener:
• Press and hold the CODE button for 4-5 seconds. The display shows “7”,
whichthenstartsashingandturnsoff.
• When “7” turns off, the display instead shows “0” and goes into standby
mode. This means that the remote control codes have been deleted from the
garage door opener.
Changing the battery in the remote control