18
Caution!
• Danger of improper battery replacement. Only replace the battery with the
same or equivalent type.
• Use leak-proof batteries.
• Loosen the screws on the back of the remote control and remove the cover.
• Replace the battery.
• Check that the poles (+/-) are correctly aligned. Place the negative pole
against the spring contact.
• Replace the cover and screw it back into place.
Wireless keypad (optional extra, must be purchased separately)
The wireless keypad must be connected as follows:
• Press the CODE button on the control panel once. The display shows “7”.
Enter “11” and press the ARROW TO LEFT button. Then enter “11” and press
the ARROW TO LEFT button again.
• Thedisplayshowsaashing“7”.Thismeansthatthewirelesskeypadhas
been added correctly. (The remote controls supplied are already added upon
delivery and require no additional pairing.)
• Each keypad can operate up to 2 door openers, so you can program one
function arrow button for each motor unit.
• The default code from the factory is 11 for the left arrow button and 22
for the right arrow button. You can program a new code by following the
instructions supplied with your wireless keypad.
Optional extras
To Next Page
Loading...
