Main Menu
Output Mode
TX Mute Key
Auto Recording
Output Volume
Low Cut
Speaker
Set TX Time A&B
Sub Menu
Mono
Stereo
Safety Track
Enable
Disable
Enable
Disable
00~15
75Hz
150Hz
O
Enable
Disable
Enter
Description
Signal from the transmitter or both transmitters can be
mixed together and recorded identically to the left and
right tracks.
Signals from each transmitter can be recorded to a
separate track.
Similar to Mono mode, the audio of the right track will be
recorded in -12dB in case of distortion in your recordings.
The mute control of the transmitters’ power button
is activated.
The mute control of the transmitters’ power button is
deactivated to prevent inadvertent operation.
When this mode is activated, the transmitter will start
recording audio as soon as it is switched on.
The onboard recording is disabled by default when the
transmitter is switched on.
The output gain level of the receiver can be reduced if
the sound is distorted. The setting is retained even after
the power is turned o. (Default to 06)
Sounds that are 75Hz or lower will be filtered.
Sounds that are 150Hz or lower will be filtered.
/
Format TX A&B
Backlight
Language
Yes?
No?
On
10s
30s
60s
简体中文
English
After selecting Yes, the onboard recording files on the
transmitters will be erased. Please use it with caution.
It is impossible to format the transmitters while it is
recording.
The backlight always stays on. (Default setting)
The backlight will turn o if no operation occurs for
10 seconds.
The backlight will turn o if no operation occurs for
30 seconds.
The backlight will turn o if no operation occurs for
60 seconds.
Default to English.
• Set the date and time so that all recording files will
include a time-stamp when exported.
• On the page, press and hold the M button twice to
access the setting page. Press to move the cursor→press
and hold to access the options→press to adjust the value
→press and hold to save the settings. Finally, press it to
move the cursor on “SAVE”, and then press and hold to
confirm and exit. To exit directly, press the power button.
Every time the receiver is turned on, the feature will be
enabled by default. Sound can be played directly without
unplugging the receiver inserted into an adapter.
/
To Next Page
Loading...
