EasyManua.ls Logo

Bradford White D-38T-155 - User Manual

Bradford White D-38T-155
44 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Save this manual for future reference
Manual 47985A
SERVICE
MANUAL
Troubleshooting Guide
and Instructions for Service
(To be performed ONLY by
qualified service providers)
Models Covered
by This Manual:
For The Bradford White
“D” Series Models:
D38T155
D75T(125,160,300)
D65T(370,399)
D80T(180,199,250)
D80T(425,505)
D100T(199,250)
D80L(399,450,505)
D100L(199,250,270,300)
D100S(199,250)
Gas Water Heaters
COMMERCIAL 24 VOLT FLUE DAMPER
SERIES WATER HEATER WITH HONEYWELL
INTEGRATED CONTROL SYSTEM
®

Table of Contents

Questions and Answers

  • R
    rodgersamandaAug 10, 2025
    Why does my Bradford White Water Heater display six flashes, then three flashes, with a three-second pause (Soft lockout)?
    • B
      bakernatalieAug 10, 2025
      The 'six flashes, then three flashes' error on your Bradford White Water Heater indicates a soft lockout, which could be due to: * Unstable pilot. * Pilot tube blocked or restricted. * Oxidation build up on pilot electrode. * Wire damage to pilot assembly or bad connection at gas valve. * Insufficient combustion air. * Low gas pressure. The system resets automatically after 5 minutes.
  • B
    Bryan AndersonAug 14, 2025
    What does it mean when my Bradford White D-38T-155 Water Heater shows six flashes, then two flashes, with a three second pause (Soft lockout)?
    • R
      ritterlisaAug 14, 2025
      If your Bradford White Water Heater is showing six flashes followed by two flashes, with a three-second pause, it signifies a soft lockout. This may be caused by: * Pressure switch tubing kinked or blocked. * Vent blockage or improper vent configuration. * Vent termination being affected by windy conditions. * Blower not spinning up to speed. * Vent temperature too high. * Faulty pressure switch or blower temperature switch. The system is designed to automatically reset after 5 minutes.
  • L
    Linda JohnsonAug 20, 2025
    What does it mean when my Bradford White D-38T-155 shows eight flashes, three flashes, three second pause?
    • D
      Dustin CarrAug 20, 2025
      If your Bradford White Water Heater displays an error code of eight flashes followed by three flashes, verify the control is not wet or physically damaged. You can also try resetting the control on/off switch. If the 8?3 error persists, replace the electronic module.
  • M
    michaelharrisAug 25, 2025
    What does it mean when my Bradford White D-38T-155 shows eight flashes, four flashes, three second pause?
    • C
      Christopher CraigAug 26, 2025
      If your Bradford White Water Heater displays an error code of eight flashes followed by four flashes, verify the control is not wet or physically damaged. You can also try resetting the control on/off switch. If the 8?4 error persists, replace the gas control.
  • M
    Megan RossAug 29, 2025
    What does it mean when my Bradford White D-38T-155 Water Heater shows eight flashes, two flashes, three second pause?
    • A
      Amy JenningsAug 29, 2025
      If your Bradford White Water Heater is showing eight flashes followed by two flashes, with a three-second pause, it could be due to damage to the sensor or wire in the control’s well, or the control’s sensor resistance being out of range. In either case, replace the control.
  • M
    Melissa JacksonSep 4, 2025
    What does it mean when my Bradford White D-38T-155 Water Heater shows eight flashes, one flash, three second pause?
    • M
      Mary RoseSep 4, 2025
      If your Bradford White Water Heater is showing eight flashes followed by one flash, with a three-second pause, it indicates that the flammable vapor sensor is out of specification, possibly shorted.

Bradford White D-38T-155 Specifications

General IconGeneral
BrandBradford White
ModelD-38T-155
CategoryWater Heater
LanguageEnglish

Related product manuals