Bradley 817 Series - User Manual

Installation
P.O. Box 309
Menomonee Falls, WI 53052 USA
800 BRADLEY (800 272 3539)
+1 262 251 6000
bradleycorp.com
WARNING
All mounting hardware is supplied by installer and must be appropriate for wall construction. Wall anchors/
backing used must provide adequate support for the intended load requirements.
Grab bars are no stronger than the anchors and walls to which they are attached, and therefore, must be
firmly secured in order to support the intended load requirements. To avoid potential injury, the building
owner or maintenance personnel should remove the grab bar from service if the mounting is not adequately
secured to the wall or if there are any observed product defects.
CAUTION
Personal Protective Equipment (PPE) is required during the installation of this product.
IMPORTANT
Read this entire installation manual to ensure proper installation. When finished with the installation, file
this manual with the owner or maintenance department. Compliance and conformity to local codes and
ordinances is the responsibility of the installer.
Separate parts from packaging and make sure all parts are accounted for before discarding any packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
Product warranties may be found under "Products" on our website at www.bradleycorp.com.
Grab Bars -
Exposed Mounting
817, 837 & 857 Series
500-377 Rev. A; ECN 18-15-009
© 2018 Bradley
Page 1 of 2 3/20/2018
-001 configuration shown. See Bradley's
website for other configurations.

Summary

General Installation Guidance

Installation Warnings

Mounting hardware must be appropriate for wall construction and provide adequate support for intended load requirements.

Installation Caution

Personal Protective Equipment (PPE) is required during the installation of this product.

Important Installation Notes

Read manual thoroughly and file with owner or maintenance department after installation. Installer responsible for local code compliance.

Installation Steps and Dimensions

Pre-installation Verification

Verify all rough-in dimensions prior to installation. Wall must be reinforced to support the grab bar's intended load.

Mounting Procedure

Use bar as template to mark holes, drill, set anchors, and mount grab bar with installer-supplied screws.

Mounting Flange Dimensions

Details of the grab bar's flange dimensions, including diameter, hole spacing, and wall clearance.

Bradley 817 Series Specifications

General

Brand	Bradley
Model	817 Series
Category	Bathroom Aid
Language	English