Need help?Do you have a question about the Braemar ECOSTAR SH25 and is the answer not in the manual?
Describes the heater's startup process, including safety checks, fan activation, and ignition.
Use a damp cloth for cleaning; avoid solvents and abrasive cleaners to prevent surface damage.
Annual servicing by an authorised agent is recommended for optimal gas appliance performance.
Overview of the control panel, detailing indicators like Child Lock, Eco mode, and temperature settings.
Press ON/OFF button; indicators illuminate red; heater starts if room temp is below set temp.
Press ON/OFF button; indicators switch off; fan cools unit until it reaches a safe temperature.
Use UP/DOWN buttons to increase/decrease set temperature between 16°C and 28°C.
Press and hold DOWN for 3 seconds; green indicator shows mode active for energy efficiency.
Press and hold UP for 3 seconds; orange indicator shows controls are locked, preventing accidental changes.
Do not operate before reading, avoid placing items against unit, keep away from flammables.
Continuously monitors temp, adjusts gas rate/fan speed, turns off when set temp is reached.
Burners turn off, fan runs to cool the heater, run-on time varies by burner speed.
Fields for recording installation date, installer name, and installer phone number.
Contact numbers for warranty/service and sales inquiries.
Provides checks for issues like no indicator lights, unit not turning on, or burner not igniting.
Explains how fault codes are displayed via indicator flashes and required actions.
General| Heating Capacity | 2.5kW |
|---|---|
| Location | Indoor |
| Voltage | 230V |
| Frequency | 50Hz |
| Overheat Protection | Yes |
| Installation Type | Wall-mounted |
| Thermostat | Yes |
To Next Page
