BrandMotion 9002-8848 User Manual


8848 Instructions 12-18-14.docx Page 1 of 5
Jeep Wrangler Adjustable Rear Vision Camera, 2007 – Current
(Kit # 9002-8848)
Items Included in the Kit
Camera
Chassis Harness
Power Harness
Zip lock bag with 15 Wire Ties & 3 Push Nuts
Camera Extension Bracket
These Instructions
Required Tools & Supplies
T15 & T20 Torx Bits
7mm & 10mm Sockets
Phillips Screwdriver
3/8” Wrench or Socket Drive
Plastic Trim Removal Tool
Soldering Iron, Solder, & Heat Shrink Tubing
(RECOMMENDED) or T-taps as an alternate
splicing method
Electrical Tape
Install Camera
Step 1: Loosen lug nuts to remove spare tire.
Step 2: Slide Camera on studs placing harness end
inside of tire carrier.
Step 3: Adjust Camera head to fit your specific wheel.
Bracket is shipped in factory wheel configuration.
Adjustment Bracket for Camera Clearance using Phillips
Screwdriver and 3/8” Wrench or Socket Drive
Note: Short Bracket has been designed for Factory
offset wheels. Use the Long Bracket for wheels with
larger offsets.

BrandMotion 9002-8848 Specifications

General

G-Sensor	Yes
Loop Recording	Yes
Parking Mode	Yes
Night Vision	Yes
Storage	Micro SD Card
Power Source	12V

Summary

Install Camera

Step 1: Loosen lug nuts to remove spare tire

Loosen lug nuts to remove the spare tire for camera installation.

Step 2: Slide Camera on studs placing harness end inside of tire carrier

Mount camera on studs, routing harness inside the tire carrier.

Install Chassis Harness

Step 4: Remove spare tire and slide (3) supplied Push Nuts on the studs

Remove spare tire and attach push nuts to mounting studs.

Step 6: Insert connector from Camera connector through the rear gate vent behind tire carrier

Route camera connector through the rear gate vent.

Step 9: Secure Chassis Harness to existing harness with wire ties

Secure chassis harness to existing wiring with wire ties.

Step 10: Secure Chassis Harness to existing harness with wire ties

Secure chassis harness to vehicle wiring using supplied ties.

Step 11: Secure Chassis Harness to fabric factory wire cover

Step 15: Gain access to run Chassis Harness along existing harness

Step 16: Pull back carpet and continue running Chassis Harness forward

Step 17: Run Chassis Harness under B-pillar cover to passenger door sill

Step 21: Disconnect harness from window switches

Step 25: Remove center stack/cluster surround

Step 26: Remove glove box for access and run Mirror Harness toward center of dash

Step 28: Connecting Power harness

Connect the power harness by splicing wires to the power point.

Step 29: Connect Chassis Harness to Power Harness

Step 30: Plug the Chassis Harness RCA connector into your aftermarket display

Connect the chassis harness RCA connector to the aftermarket display.

Step 31: Test the system

Test system by starting vehicle and shifting to reverse to check camera display.

Step 32: Reassemble vehicle