8
This appliance is designed for household use only.
Description
1 Foil & Cutter cassette
2 Long hair trimmer
3 Precision setting switch ( ) (380s only)
4 On/off switch
5 Charging lights (green)
6 Low-charge light (red)
7 Replacement light for shaving parts
8 Shaver power socket
9 Special cord set
10 Charging stand
11 Case (380s only)
12 Protective cap (340s only)
Charging
The best environmental temperature for charging is between 60 °F to 95 °F /
15 °C to 35 °C. Do not expose the shaver to temperatures higher than
122 °F / 50 °C for extended periods of time.
• Using the special cord set (9), connect the shaver or the charging stand (10)
to an electrical outlet with the motor switched off.
• When charging for the first time, leave the shaver to charge continuously
for 4 hours.
• Once the shaver is completely charged, discharge the shaver through
normal use. Then recharge to full capacity. Subsequent charges will take
about 1 hour.
• A full charge provides up to 45 minutes of cordless shaving time depend-
ing on your beard growth. However, the maximum battery capacity will
only be reached after several charging/discharging cycles.
• 5-minute quick charge is sufficient for a shave.
Charging lights
The green charging lights (5) show the charge status of the batteries
(340s: 1 charging light). The green charging light blinks when the shaver is
being charged or switched on. When the battery is fully charged, all green
charging lights (340s: 1 charging light) shine permanently, provided the
shaver is connected to an electrical outlet.
Low-charge light
The red low-charge light flashes when the battery is running low. You should
be able to finish your shave.
96233682_380_NA_S6-36.indd 896233682_380_NA_S6-36.indd 8 08.11.12 14:3508.11.12 14:35
To Next Page
Loading...
Need help?
General
