9
Long hair trimmer (2)
To trim sideburns, moustache or beard, slide the long hair trimmer upwards.
Precision mode switch
(3)
For precise handling in hard to shave areas (e.g. under the nose) slide the switch (3) to
the right position. One foil will be lowered.
Tips for a perfect dry shave
For best results, Braun recommends that you follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your skin.
3. Stretch your skin and shave against the direction of your beard growth.
Cleaning
Regular cleaning ensures better shaving performance.
Cleaning under running water:
• Switch the shaver on (cordless). Rinse the shaver head and the precision mode
switch under hot running water until all residues have been removed. You may use
liquid soap without abrasive substances. Rinse off all foam and let the shaver run
for a few more seconds.
• Next, switch off the shaver, remove the Foil & Cutter cassette (1) and let it dry.
• If you regularly clean the shaver under water, then once a week apply a drop of light
machine oil (not included) onto the long hair trimmer (2) and Foil & Cutter cassette (1).
The shaver should be cleaned after each foam usage.
Cleaning with a brush:
• Switch off the shaver. Remove the Foil & Cutter cassette and tap it out on a flat
surface.
• Using a brush, clean the inner area of the shaver head. However, do not clean the
Foil & Cutter cassette with a brush as this may damage it.
Keeping your shaver in top shape
Replacement light for shaving parts / Reset
To maintain 100% shaving performance, replace the Foil & Cutter cassette (1), when the
replacement light for shaving parts (7) comes on after about 18 months or when worn.
The replacement light will remind you during the next 7 shaves to replace the Foil & Cutter
cassette. Then the shaver will automatically reset the display. After you have replaced
the Foil & Cutter cassette (1), press the on/off switch (4) for at least 5 seconds to reset
the counter.
While doing so, the replacement light blinks and goes off when the reset is complete.
The manual reset can be done at any time.
97556209_3080s-3010BT_NA_S6-36.indd 997556209_3080s-3010BT_NA_S6-36.indd 9 16.07.15 11:4716.07.15 11:47
CSS APPROVED Effective Date 17Jul2015 GMT - Printed 04Aug2015 Page 9 of 36
To Next Page
Loading...
Need help?
General
