10
Clean&Renew (C)
Braun Clean&Renew has been developed for cleaning, charging and storing
your shaver.
Clean your shaver daily in the Clean&Renew.
During the automated cleaning process, the shaver is switched on and off
at intervals to obtain best cleaning results. Since the specially formulated
cleaning fluid contains a small amount of oil, the cleaning procedure also
fulfils the lubrication needs of the shaver.
Description
1 Start/release button
2 Contact bow
3 Lift button for cartridge exchange
4 Level indicator
5 Cleaning cartridge
Installing the cartridge
• Press the lift button (3) to open the housing.
• Hold the cartridge down on a flat, stable surface (e.g. table). Carefully
remove the lid from the cartridge. Slide the cartridge into the base as
far as it will go.
• Slowly close the housing by pushing it down until it locks.
Replacing the cartridge
After having pressed the lift button to open the housing, wait for a few
seconds before removing the used cartridge.
Before discarding the used cartridge, make sure to close the openings
using the lid of the new cartridge, since the used cartridge will contain
contaminated cleaning solution.
The used cartridge can be disposed of in the household waste.
Operating your Clean&Renew
• Connect your Clean&Renew with the cord set to the mains electricity
supply. The special socket at the back is adjustable to save space. After
each shave, switch the shaver off and put it into the Clean&Renew, upside
down and with the front showing.
• Push the start/release button (1) to lock and connect the shaver. The
cleaning process will start. The yellow light on the shaver will flash during
the complete process.
96314373_390cc4_S6-112_CEE.indd 1096314373_390cc4_S6-112_CEE.indd 10 18.04.13 13:5918.04.13 13:59
To Next Page
Loading...
