9
Memory mode
The last temperature taken before the thermometer powers down is
stored in memory. To enter the memory mode, press the /mem
button.
The last stored temperature is displayed along with the MEM symbol.
Even in memory mode, a new temperature can be taken provided
that the ready symbol
is shown.
To quit the memory mode, press the /mem button again.
LCD light
for easy nighttime reading
Changing the temperature scale
This thermometer is shipped with the Celsius temperature scale
activated. If you wish to switch to Fahrenheit (°F), proceed as
follows:
ø
Turn on the thermometer.
(If it is already turned on, make sure it is not in memory mode.)
ø
Press the
/mem
button and keep it pressed. Then press and
release the activation button to switch over to the «change
temperature scale» mode.
ø
By pressing the activation button again, the Fahrenheit scale is
activated, «°F» is displayed on the LCD. Each further pressing
of the activation button toggles the scale between °C and °F.
ø
Release the
/mem
button to return to the ready symbol .
The temperature stored in memory will automatically be converted
to the selected scale when displayed on the LCD.
6014001/01_PRO3000_MN Seite 9 Dienstag, 20. Juni 2000 9:46 09
To Next Page
Loading...
