32
Shaving with the cord
If the shaver has run out of power (discharged), you may also shave with the shaver
connected to an electrical outlet via the special cord set.
Travel lock
• Activation: By pressing the on/off switch (4) for 3 seconds the shaver is locked.
This is confirmed by a beep sound and the lock symbol in the display. Afterwards the
display turns off.
• Deactivation: By pressing the on/off switch for 3 seconds the shaver is unlocked
again.
Manual cleaning of the shaver (see fig. B/C)
Cleaning under running water
• Switch on the shaver (cordless) and rinse the shaver head under hot running
water until all residues have been removed. You may use liquid soap without
abrasive substances. Rinse off all foam and let the shaver run for a few more
seconds.
• Next, switch off the shaver, press the release buttons (2) to remove the Foil & Cutter
cassette (1) and let it dry completely.
• If you regularly clean the shaver under water, then once a week apply a drop of light
machine oil (not included) on top of the Foil & Cutter cassette and the long hair
trimmer.
Cleaning with a brush
• Switch off the shaver. Remove the Foil & Cutter cassette (1) and tap it out on a flat
surface. Using the brush, clean the inner area of the pivoting head. Do not clean the
cassette with the brush as this may damage it!
The Foil & Cutter cassette can be attached either way. There is no impact on the
shaving performance.
Clean&Charge Station
The Clean&Charge Station has been developed for cleaning, charging, lubricating,
disinfecting, drying and storing your Braun shaver.
12 Station power socket
13 Lift button for cartridge exchange
14 Station-to-shaver contacts
15 Clean&Charge Station display
15a Level indicator
15b Status light
16 Start button
17 Cleaning cartridge
90778960_Series_9_9250cc_Japan.indd 3290778960_Series_9_9250cc_Japan.indd 32 10.02.16 13:3110.02.16 13:31
CSS APPROVED Effective Date 23Mar2016 GMT - Printed 30Jun2016 Page 32 of 40
To Next Page
Loading...
