Braun BFD104BE User Manual

12 13
English
Cleaning the particle sensor
Ensure that the air purifier is unplugged from the wall outlet before cleaning the particle sensor.
The particle sensor needs to be cleaned every 3 months to optimize performance. Follow the steps
below to clean the sensor when the indicator is illuminated:
1
Find the brush icon at the side of
air purifier.
2
Remove the sensor cover.
3
Use a dry cotton swab to clean
the lens.
4
Return the sensor cover after
cleaning.
8
4
2
1
5
1sec
2x
Reset the particle sensor
indicator by pressing the reset
button twice in 1 second.
DO NOT use any
cleaners or liquids
when cleaning the
particle sensor.
Cleaning and storage
We recommend that you clean the air purifier at least once every 3 months and before extended storage.
Unplug unit from outlet before cleaning. Use only a dry cloth to wipe the external surfaces of the air
purifier.
Do not use water, wax polish, or any chemical solution.
If your air purifier will not be used for more than 30 days, we recommend:
• Remove the ECO filter and odour & VOC filter from the air purifier.
• Place them into an airtight plastic bag for storage.
Accessories and replacement filters
Odour & VOC filter replacement: BRFV1E
You may purchase the Braun odour & VOC filter from the retailer where you purchased the air purifier.
Troubleshooting
Problem Solution
My unit will not turn on. Please ensure the unit is plugged into a working outlet.
My air purifier is starting to make
noise and the air output is lower.
The filters may be dirty. High amounts of contaminants
can block the pores in the filters and stop the air from
moving through them. The filters should be cleaned/
replaced.
The electronic filter indicator light has
not illuminated but the filter is dirty
when checked.
The indicator runs on a timer. When the air has more
particles than average, the filter may capture airborne
particles faster than indicated on the display. The
indicator is used as a guideline and can vary with
individual environmental conditions. Clean or replace
the filter as needed and reset the electronic filter
indicator based on the instructions on page 7.
The air quality indicator is not
changing even when the air becomes
cleaner.
The particle sensor may be dirty. Please clean the
sensor based on the instructions on page 12.
The electronic filter indicator alert
is still illuminated after cleaning and
replacing the filter.
The electronic filter indicator alert may not have been
reset. Please hold the reset button for 2 seconds until
the alert light flashes twice and shuts off.
The air quality seems to have no
improvement after the air purifier has
been in use.
For best results, the purifier should operate 24 hours a
day when possible. This unit will be more effective when
doors and windows are closed.
The odour & VOC filter is very dirty. The odour & VOC filter is not washable. It should be
replaced every 6 months.
What are VOCs? Volatile Organic Compounds (VOCs) are emitted from
various solids and liquids such as paints, cleaning
supplies, building materials, and permanent markers.
Some of these compounds can have adverse short
and long term effects and consistently have higher
concentrations indoors than outside.
(Source: http://www.epa.gov/iaq/voc.html)

Braun BFD104BE Specifications

General

Brand	Braun
Model	BFD104BE
Category	Air Cleaner
Language	English