7
Measuring
For a reliable blood pressure measurement, please follow
the instructions below.
To open the cuff, press the release button (G) underneath
the cuff closure.
1. Place the monitor housing on the slim side of your bare
forearm with the monitor facing up. The distance aid (I)
helps you to keep the required 2 cm
distance to your
palm line.
2. To close the cuff, hold the appliance against your
body. Then take hold of the cuff closure, pull out
the cuff and insert the cuff closure in the monitor
housing until it locks into place. The cuff will adjust
automatically to length needed for your wrist. Once
cuff is closed, do not move the appliance anymore.
If you want to change the monitor position on your
arm, open and close the cuff once again.
3. Press the red on/off button (C).
4. Put the hand with the appliance on the other upper
arm as shown. Slowly move the hand upward along
the upper arm. Watch the positioning system (A) and
move your hand up or down according to the direction
of the arrow shown.
distance
2 cm
2 cm
memo
click!
6084401_BP3550/60_S4-80 Seite 7 Mittwoch, 20. Dezember 2006 1:56 13
To Next Page
Loading...
Need help?
General
