3202 - 10
BINC Rev: 4/97 Service Documentation
Service Information
BAG Rev: 2/97 3202
Technical Data
Nominal voltage/frequency: 120V 60 Hz
Driving motor: DC motor B2-DC
Nominal power: approx. 600 W (load dependent)
No-load power: approx. 120 - 180 Watts
No-load speed position 2: approx. 240 - 300 r.p.m. at the bowl coupling
No-load speed position 14: approx. 1850 - 2200 r.p.m. at the bowl coupling
No-load speed position 2: approx. 1100 r.p.m. at the mixing coupling
No-load speed position 14: approx. 10500 r.p.m. at the mixing coupling
Overload protection: electronic controls, see use instructions
Mixing arm rotation: approx. 14 - 130 r.p.m. mixing arm into the bowl
approx. 144 - 1320 r.p.m. whisk into the mixing arm
Length of mains lead: approx. 1.30 m
Note about the screws The special screws (25/35), can only be removed with a screw
driver furnished with a special blade insert. These special blade
inserts for the screwdriver can be ordered from the parts department.
Because of approval-board requirements and reasons of safety, only
the special screws (35) into the base plate must be used to avoid
tampering by un-authorized persons.
Note about the PCB Attention, charging capacitor on the PCB (36) is charged, use a
resistor of 10-50 Ohms to discharge.
Note about the wiring All connecting cables are provided with self-securing plugs. In order
be bent down slightly. These pins must not be deformed or broken
off. In case that the plug does not snap in correctly to the connecting
contact, a completely new cable must be used.
Note about the speed It is not possible to adjust the speed. In case that the number of
revolutions does not correspond to the technical data, the device is
defective.
To Next Page
Loading...
