2. Installing & Replacing the Battery
Place the upside of the remote control down, press down on the ridged area of
the battery cover and pull towards you to remove the tray. Place one CR2025
lithium button-cell battery on the tray with the positive “+”side facing you.
Reinsert the tray.
3. Getting Started
3.1 Plug one end of the included AC adapter into a standard 80-240V AC electrical
outlet and the other end into the DC in of the frame.
3.2. Remove the protective film covering the LCD.
3.3. Remove the plastic battery insulator from the battery compartment and make
sure the remote control has a battery inside. Please refer to “Installing & Replacing
Battery” if you need a new battery.
4. Operating Instruction
After turning the Units, it will show the start-up logo, and then show the main
interface after 3~5 seconds.
4.1 Main Menu
It supports SD/ SDHC/ MMC and USB 2.0. Then press RETURN twice to access
to photo, music, video, calendar and settings choose interface. Press ENTER
to confirm the item you want.
Note: 1) Make sure there are supported picture, music and video files in the Card or
USB device.
2) You can also select Movie, Photo+ Music, off in the Setup Menu
To Next Page
Loading...
Need help?
General
