Braun ExactFit 5 - Morning Hypertension Setting

8
Morning average (for BP5900PH-EMEA only)
• Press the “average ” (3) button again into “morning
average
” mode, the morning measurements
in memory within past 7 days will show on LCD.
• If there is no data in memory within past 7
days, “
” will show on LCD.
Evening average (for BP5900PH-EMEA only)
• Press the “average ” (3) button once again into “evening
average
” mode, the evening measurements in memory
within past 7 days will show on LCD.
• If there is no data in memory within past 7 days, “
” will
show on LCD.
Erasing data
• Press the “memory
M
” (2) button into memory mode.
• Press and hold the “mode
” (5) button and then press the
“set
” (4) button, all the stored data will be erased and
CLR will show on screen.
• To check if the data was erased, press the “memory
M
” (2)
button. No data should show up on screen, but date, time
and M:00.
Morning hypertension setting (for BP5900PH-EMEA only)
Morning hypertension symbol will appear when morning average is above your
pre-congured systolic rate and/or pre-congured diastolic rate, and/or one or both of
these measurements is 20% or more above evening average.
** Your pre-congured systolic / diastolic should be decided between you and your
doctor or healthcare provider.
• After setting date and time, press “mode
” (5) button into
“morning hypertension
” setting mode “- - ” on systolic
position will ash for systolic setting.
• Press “set
” (4) button, LCD will appear 135 mmHg for SYS
as the internal pre-set value, then press “Set
” button
repeatedly to set his own value (range from 70~250 mmHg)
• Press “mode
” (5) button again into “morning hypertension
” setting mode “ - - ” on diastolic position will ash for
diastolic setting.
• Press “SET
” (4) button, LCD will appear 85 mmHg for DIA
as the internal pre-set value, then user presses “set
” button
to set his own value (range for DIA is 40 ~ 115 mmHg).
• User can press start/stop
(1) button to exit setting mode
and go back to standby at any step.