5704 - 14
BINC Rev: 11/97 Service Documentation
Service Information
BAG Rev: 8/97 5704
Display Super AT
Jumping display. - Motor current too high. - Exchange swivel frame, shaving
foil frame, cutting head and
motor.
- Damaged motor contacts. - Exchange motor, clean and
grease contacts on PCB
- Not completely charged. - Recharge for min. 1 hour.
- Defective electronics. - Exchange PCB.
Display unlogical - Self-test is activated. - Instruct customer.
(short term).
Display does not - Not fully recharged. - Recharge for min. 1 hour.
return to "0".
No display - Not recharged. - Recharge for min. 4 hrs.
Missing segments. - Faulty display contacts. - Clean contact strips and
surrounding area; exchange
contact strips, if necessary.
Spots on display. - Loose display. - Replace display.
Visible dirt particles. - Display seal is not - Clean; new seal.
orderly assembled.
Black display after - Defective electronics. - Exchange PCB.
recharging process.
Red LED is not - Not fully recharged. - Recharge for min. 1 hour.
illuminated. - Defective electronics. - Exchange PCB.
Green LED is not - Defective electronics. - Exchange PCB.
illuminated.
To Previous Page
Loading...
