5704 - 13
BINC Rev: 11/97 Service Documentation
Service Information
BAG Rev: 8/97 5704
Cutting head does - Bearing axis 2 is too rough. - Exchange cutting heads.
not snap in. - Not orderly snapped in after - Instruct customer. (Attach
cleaning 90°)
Hair dust is falling - Dust catcher is overloaded. - Instruct customer.
out of the shaver.
Shaver does not work. - No display - Recharge for min. 4 hrs.
- Display "0" (SAT) - Recharge for min. 1 hour.
- Defective switch - Clean and grease contacts;
exchange chassis.
- Defective motor contact - Exchange motor; clean and
grease contact on PCB.
- Short hair system eccenter - Dismantle and reassemble
jumped out of swivel slot swivel frame; exchange if
necessary.
Lock switch does not - Spring is not orderly snapped -Spring to be snapped in
function. in (Service) correctly.
Sliding plate does not - Switch spring unhinged, - Exchange sliding plate.
function. overstretched
- When switching back from - Determined by the concept;
pos. 3 to pos. 1, pos. 2 is passed. instruct customer.
LHT cannot be - Broken locking pin. - Exchange preassembled
switched on. chassis
Head does not swing; - Broken locking pin. - Exchange preassembled
hooks. chassis
Sluggish head. - Wrong bearing screw. - Exchange screw.
(Service)
- Eccenter positioned too high. - Exchange preassembled
motor.
Shaver is open. - False operation. - Instruct customer,
exchange disposal unit
Shaver is warming up - Battery lug is torn off. - Exchange PCB.
considerably during - Faulty joint contact - Exchange PCB.
recharging process - Defective electronics - Exchange PCB.
(SAT).
Time of operation - Not completely charged - Recharge for min. 4 hrs.
is too short. - Defective electronics - Exchange PCB.
To Next Page
Loading...
