Chopping blade
Chopper bowl
Anti-slip rubber ring
9. 500 ml chopper accessory «ca»
Lid (with gear)
Chopping blade
Chopper bowl
Anti-slip rubber ring
10. 1250 ml chopper accessory «bc»
Lid (with gear)
Chopping blade
Ice blade
Chopper bowl
Anti-slip rubber ring
How to Use the Appliance
Blending Shaft (A)
The hand blender is perfectly suited for preparing dips, sauces, salad dressings, soups, baby food, as well as drinks,
smoothies and milkshakes. For best results, use the highest speed.
Assembly and Operation
Attach the blending shaft (5) to the motor part until it clicks.
Place the blending shaft into the mixture to be blended. Then switch the appliance on.
Blend ingredients to the desired consistency using a gentle up-and-down motion.
After use, unplug the hand blender and press the release buttons (4) to detach the blending shaft.
Caution
If using the appliance to purée hot food in a saucepan or pot, remove the saucepan or pot from the heat source
and ensure the liquid is not boiling. Allow hot food to cool slightly to avoid risk of scalding.
Do not let the hand blender sit in a hot pan on the cooktop when not in use.
Recipe Example:
Mayonnaise 250 g oil (e.g. sunflower oil)
1 egg and 1 extra egg yolk
1–2 tbsp. vinegar
Salt and pepper to taste
Place all ingredients (at room temperature) into the beaker in the order as above.
Place the hand blender at the bottom of the beaker. Blend at maximum speed until the oil starts emulsifying.
With the hand blender still running, slowly raise the shaft to the top of the mixture and back down to incorporate
the rest of the oil.
NOTE: Processing time: approx. 1 minute for salads and up to 2 minutes for a thicker mayonnaise (e.g. for dip).
Whisk Accessory (A)
Use the whisk only for whipping cream, beating egg whites, making sponge cakes and ready-mix desserts.
Assembly and Operation
Attach the whisk (7b) to the gearbox (7a).
Align the motor part with the assembled whisk attachment and push the pieces together until they click.
After use, unplug and press the release buttons to detach the motor part. Then pull the whisk out of the
gearbox.
Tips for Best Results
To Next Page
Loading...
