Braun MultiServe KF 901AN - Page 15

17
EN Pause during brewing
process
1. Move the lever (E) to “Drip Stop”
position.
2. The brewing process will be paused
and the selected brewing mode is
flashing.
3. The lever should be moved back to
the “Coffee” position within maxi-
mum 2 minutes.
4. The brewing process will be continued.
NOTE: If the lever is not moved back
to “Coffee” position, the brewing pro-
cess is terminated with an acoustic
signal. If you pause the brewing
process the GOLD/SCA brew mode
requirements might not be met.
FR Pause during brewing
process
1. Move the lever (E) to “Drip Stop”
position.
2. The brewing process will be paused
and the selected brewing mode is
flashing.
3. The lever should be moved back to
the “Coffee” position within maxi-
mum 2 minutes.
4. The brewing process will be continued.
NOTE: If the lever is not moved back
to “Coffee” position, the brewing pro-
cess is terminated with an acoustic
signal. If you pause the brewing
process the GOLD/SCA brew mode
requirements might not be met.
ES Pause during brewing
process
1. Move the lever (E) to “Drip Stop”
position.
2. The brewing process will be paused
and the selected brewing mode is
flashing.
3. The lever should be moved back to
the “Coffee” position within maxi-
mum 2 minutes.
4. The brewing process will be continued.
NOTE: If the lever is not moved back
to “Coffee” position, the brewing pro-
cess is terminated with an acoustic
signal. If you pause the brewing
process the GOLD/SCA brew mode
requirements might not be met.
EN Dispensing hot water* FR Dispensing hot water* ES Dispensing hot water*
1. Fill water in the water reservoir.
2. Place the carafe on the keep warm
plate or a cup on the cup holder.
3. Press the On/Off button.
4. Place the lever (E) in position “Hot
Water”. The buttons “Water” and
“Temp” are illuminated. The default
temperature is shown in the display.
1. Fill water in the water reservoir.
2. Place the carafe on the keep warm
plate or a cup on the cup holder.
3. Press the On/Off button.
4. Place the lever (E) in position “Hot
Water”. The buttons “Water” and
“Temp” are illuminated. The default
temperature is shown in the display.
1. Fill water in the water reservoir.
2. Place the carafe on the keep warm
plate or a cup on the cup holder.
3. Press the On/Off button.
4. Place the lever (E) in position “Hot
Water”. The buttons “Water” and
“Temp” are illuminated. The default
temperature is shown in the display.
* certain models only * certain models only * certain models only
BRAUN_UI_KF9050_BK_-_KF9070_SI_V09.indd 17 21.02.19 15:15