Page 6
Lift Terminology
regarding the control switches
and their functions are provided in
the Lift Operation section.
Lift Housing: The lift housing
is the metal structure (casing)
mounted under the vehicle which
contains and protects the platform
carriage assembly. The hous-
ing contains all lift components
except the power (pump) module
when the lift is in the stowed posi-
tion.
Platform Carriage Assembly:
The platform carriage assembly
includes the platform assembly,
the lifting arms, the rolling hori-
zontal arms that carry the plat-
form assembly in and out of the
housing and the electrical/hydrau-
lic drive components that power
the lift.
Platform Assembly: The lift
platform assembly consists of the
flat aluminum plate upon which
the wheelchair is positioned, the
outer barriers, the inner roll stop
and shield handrails.
Outer Barrier: The two-stage
outer barrier system consists of a
spring-loaded tall barrier and an
electric actuator-driven short bar-
rier. The two-stage outer barrier
provides a ramp for wheelchair
loading and unloading at ground
level. Photos and further details
are provided in the Operation
Notes and Details section (pages
18-21).
Inner Roll Stop: The NUV-
L855RM24 is equipped with an
automatic inner roll stop that also
serves as the bridge plate. The
Lift Components
Refer to the Lift Terminology Il-
lustration on page 4.
Pump Module: The remote
mounted pump module consists
of the main hydraulic pump, the
manual hand pump, the electronic
control board and other electrical
components that power the lift
electric/hydraulic systems.
Hand-held Pendant Con-
trol: The hand-held pendant is
equipped with four push button
switches, (DOOR, STOW, DOWN
and UP). The momentary switch-
es activate the automatic lift
functions. Simply press the switch
labeled for the intended function.
The lift function labels illuminate
to identify the function(s). Details
To Next Page
Loading...
Need help?
General
