Braun SensorAir BFD104B User Manual

10
11
CAUTION:
•
NEVER place a wet ECO Filter in your air purifier.
•
DO NOT place the ECO Filter in a dishwasher or subject it to other extreme hot
water conditions.
•
DO NOT use any solvents, strong cleaning agents or flammable liquids to clean
the ECO Filter.
Shake the filter to remove any
excess water.
Drying the ECO filter
8
4
2
1
5
2sec
1 2 3
4
Place the filter on a towel. Allow the ECO Filter to dry for
a few hours or overnight.
When the ECO
Filter is
completely dry, place back
into the air purifier and return
the rear cover to its original
place.
Plug the unit into the power
outlet. When the unit is off,
press and hold the ECO filter
reset button for 2 seconds.
The filter indicator will flash
twice and shut off.
Ensure that the air purifier is unplugged from the wall outlet before cleaning the filter.
The ECO
Filter should be cleaned approximately once every 3 months.
Turn the power off and
unplug the air purifier.
Cleaning the ECO filter
4
2
1
1 2 3
4
5
6
7
2-3
min
Remove the ECO Filter. Rinse the filter with clean
tap water.
If the filter still appears dirty, follow step 4-7. Otherwise proceed to “Drying” section.
DO NOT leave filter in water for more than 5 minutes.
Fill a sink with lukewarm water
and add a few drops of mild
dish soap.
Gently swish the filter in the
soap solution to clean.
Soak the filter for 2-3 minutes.
DO NOT leave filter in water
for more than 5 minutes.
Rinse the filter with clean tap
water.
Note that the filter may still be discolored even after washing. This is normal staining that
occurs and will not affect performance.

Braun SensorAir BFD104B Specifications

General

Brand	Braun
Model	SensorAir BFD104B
Category	Air Cleaner
Language	English