27
During filming, the left hand was used
to support the camera by resting' on
the top of the body at the front. The
ball of the
thumb may have pressed
the meter battery test button
in
slightly
and interrupte'd the current
circuit
to
the exposure
control· system. In this
case the lens will open up to full
aperture.
Camera
runs continuously
Possible cause:
Continuous run switch next to shutter
release has been locked
in
the
position needed for the automatic
sing
Ie
-frame device.
Drive batteries are too weak
Pictures are not sharp, out of focus
Possible cause:
Eyepiece adjustment not
in
accordance with cameraman's eyesight
Before filming, the distance was
not
examined and focused at maximum
lens focal length
Check your method of holding' the camera
and modify
grip
if
necessary.
Remedy:
Return switch to normal position.
Check voltage.
Remedy:
Correct by reference to the section on
eyepiece adjustment
in
this manual.
Use the tele position of the zoom lens
for
all focusing. This is particularly important
in
tracking shots, where camera-to-subject
distance
may vary.
To Next Page
