6
Your Braun Syncro (7546 only) is supplied with a Braun
Clean&Charge (please see separate use instructions).
Important
Only use the power supply cord set provided.
A damaged cord must be replaced immediately.
Description
1 Foil protection cap 7 Charging lights
2 Shaver foil (green)
3 Cutter block 8 Low-charge light
4 Foil release button (red)
5 Long hair trimmer 9 Pilot light
6 Switch 10 Shaver socket
Technical specifications:
•
Wattage via cord set: 7 W
•
Power supply via cord set: 100-240 V
2
/50 or 60 Hz
(automatic adaptation)
•
Shaver input voltage: 12-24 V
Charging the shaver
•
First charging: Using the power supply cord set,
plug the shaver into an electrical outlet with the switch
on position «0» and charge it for at least 4 hours
(plug might get warm).
•
Once the shaver is completely charged, shave without
the cord until fully discharged. Then recharge to full
capacity again (subsequent charges will take about
1 hour).
•
A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
•
Best environmental temperature range for charging
is 60°F to 95°F / 15°C to 35°C.
Indicator lights
•
The pilot light shows that the shaver is plugged into the
outlet properly.
+35°C
+15°C
210
7540
7540
5492451_S 4-26 Seite 6 Freitag, 31. März 2000 12:54 12
To Next Page
Loading...
