Subject to change without notice.
Please do not dispose of the product in the household waste at the end of its useful
life. Disposal can take place at a Braun Service Centre or at appropriate collection
points provided in your country.
Troubleshooting Guide
PROBLEM POSSIBLE CAUSES SOLUTION
Water droplets drip on the
fabric during ironing.
The water tank lid is not properly
closed.
Press the water tank lid and check if it
is closed.
Chemicals have been put into the
water tank.
Never put chemicals or perfumes into
the water tank. Empty the water tank,
rinse it 2-3 times.
The steam trigger is overused.
Wait at least a few seconds between
each use.
Water droplets drip from the
soleplate after the iron has
been unplugged or has been
stored.
The steam regulator is set beyond
“0” level.
Set the steam regulator to “0”.
You have put the iron in horizontal
position with water inside the tank.
Empty the water tank after ironing and
place the iron vertically on a stable
surface during the cooling down.
The iron produces little or no
steam.
The water tank is empty. Refill the water tank.
The valve has collected too much
scale.
Clean the valve.
The iron is not hot enough to
produce steam.
Wait until the iron heats up and the
temperature control LED is
permanently on.
Flakes and white impurities
come out during ironing.
The iron has limescale formations
inside the steam chamber.
Run the descaling procedure (clean
the steam chamber and the valve).
The spray function or the
steam shot do not work
properly.
The water tank is empty. Refill the water tank.
The LED turns permanently
on.
There is a problem with tempera
-
ture probe.
Unplug and plug in again. If the
problem does not disappear contact
the Braun customer service.
11
DLB253492_5712710611_SI9_UI_INT.indb 11 21.12.16 10:09
To Next Page
Loading...
Need help?
General
