7
• Hold the appliance at heart level during the measurement.
• Wait approximately 3 minutes before repeating a measure-
ment.
Taking a measurement
For a reliable blood pressure measurement, please follow the in-
structions below. Apply the cu on your right wrist , when taking
a measurement. The device can also be used on your left wrist.
1. Place the monitor housing on the slim side of your bare
forearm with the monitor facing up. Keep the required 2 cm
distance to your palm line.
2. Fasten the cu on your wrist. Make sure that the cu ts
tightly.
3. Press the red on/o button (C).
4. Put the hand with the appliance on the other upper arm as
shown. Slowly move the hand upward along the upper arm.
Watch the positioning system (A) and move your hand up or
down according to the direction of the arrow shown.
2.0 cm
To Next Page
Loading...
