8
1 2
Average & memory functions
Your VitalScan 3 blood pressure monitor will automatically store 90 measurements
(VitalScan 1 model: 10 measurements). Storing is done automatically after each
completed measurement. The memory is nonvolatile. This means that you will not lose
stored data when changing batteries. However, the memory can be cleared manually.
See Deleting all measurements on page 9.
The VitalScan 3 model features an Average function to display the average
reading of the last three measurements.
Note: Average readings feature is NOT available in the VitalScan 1 model.
Recalling average readings (VitalScan 3 only)
1. To recall average readings, press button.
The average of the 3 last readings will display
along with average icon
.
2. To exit, turn device off by pressing
button.
Recalling stored readings (VitalScan 1 and VitalScan 3)
1.
Press memory button
once for average of existing memories (this step is for
VitalScan 3 only. See Recalling average readings above.) Then press
button
again. Memory icon
will appear and a number will briefly appear in the
pulse field. This number indicates which memory is being recalled. Then, the
recalled measurement will display.
2. Repeatedly pressing the
button will call up one by one all stored readings.
The number of the memory will appear first, followed by the measurement.
3. To exit the memory mode, press the
button.
To Next Page
Loading...
Need help?
General
