7
4 5 6
4. Press power button to begin. The measurement starts automatically. While
measurement is in progress, do not move or speak.
Note: If necessary to interrupt a measurement, press the
at any time. The device
immediately cancels the measurement, lowers cuff pressure and enters sleep mode.
5. The cuff will first inflate and then deflate. At the end of the measurement a final
beep sounds and the reading is displayed:
Upper (systolic) value
Lower (diastolic) value
Pulse
6.
Press the power button
to turn the product off. Otherwise the product will
turn off automatically after 1 minute. If at any time, you want to stop the
measurement, press the power button
.
7. Tests results will be saved into the memories automatically ( see Average &
memory functions below). If you don’t want store the data, press and hold the
power button
5 seconds until the M icon is flashing, then press the memory
button
to confirm operation.
Irregular heartbeat detection (only for VitalScan 3)
This symbol indicates that certain pulse irregularities were
detected during the measurement. In this case, the result may
deviate from your normal basal blood pressure – repeat the
measurement. In most cases, this is no cause for concern. However,
if the symbol appears on a regular basis (e.g. several times a week
with measurements taken daily), we advise you to tell your doctor.
CAUTION: An irregular heartbeat can be a serious medical condition
requiring medical attention. We recommend contacting your physician
if you see this icon frequently.
To Next Page
Loading...
Need help?
General
