Need help?Do you have a question about the Brauniger IQ-ONE and is the answer not in the manual?
General| Vario function | Yes |
|---|---|
| Altimeter | Yes |
| Display | LCD |
| Power source | Battery |
| Display Type | Monochrome LCD |
| Water Resistance | No |
Describes the primary operating mode for normal use, displaying various flight parameters.
Mode for adjusting instrument settings by holding keys, allowing display field changes.
Advanced mode for changing instrument settings, accessed from Set-Mode.
Overview of the graphical and digital display elements of the IQ-ONE instrument.
Procedure for safely powering down the instrument, including optional shutdown processes.
Instructions for direct access to functions using specific keys in RUN mode.
Details on using audio-related keys for functions like volume and sink alarm.
Guide to using key combinations for accessing SET and OPTION modes for various functions.
Instructions for operating the ON/OFF key for instrument power and mode selection.
Explains how the altimeter measures height based on air pressure changes.
How to use the Altitude Key to switch between ALT1 and ALT2 displays.
Procedure to set the current altitude for ALT1 using arrow keys and pre-set locations.
Setting height units and pressure units for ALT1 in Option-Mode.
Setting a reference height for ALT2, such as relative altitude to a goal.
Setting relative or absolute values for ALT2 and linking ALT1/ALT2.
Describes the graphical display of climb and sink rates on the vario-beam.
How to adjust the internal loudspeaker volume for the variometer.
Setting the basic damping (analogue integrator) for the variometer.
Setting units, digital integrator, and audio threshold for the variometer.
Adjusting the frequency range of the variometer's beep tone.
Enabling or disabling the audio scale indicator for the variometer.
Turning the sink alarm on or off and setting its trigger speed.
Setting the specific sink speed at which the alarm will activate.
Configuring temperature units and applying temperature correction to the sink alarm.
Selecting display units (km/h, kts, mph) for speed measurements.
Configuring the stall alarm to sound at a specific low speed.
Applying percentage correction to the displayed airspeed, often due to sensor mounting.
Setting how speed and temperature displays change over time.
How to cycle through time, stopwatch, and memory displays.
Setting the instrument's time and date, and choosing 12h/24h format.
Selecting the display format for time (24-hour or 12-hour AM/PM).
Graphical displays of maximum climb/sink, height, flight number, date, and time.
Entering memory set-mode to configure flight recording and barograph settings.
Details on the IQ-ONE+'s tamper-proof barograph for recording flights and parameters.
Setting recording parameters (interval, data types) and storage capacity for barograph.
How to select and delete specific recorded flights or all data from the logbook.
Specifies the type and voltage of batteries required for the instrument.
Lists common error codes and their meanings, advising on troubleshooting steps.
Procedures to follow in case of water damage to the instrument to prevent warranty invalidation.
Steps to take when the instrument malfunctions, including battery reset and dealer contact.
Disclaimer regarding BRÄUNIGER GMBH's responsibility for instrument functioning and data accuracy.
Specifications of the instrument including size, weight, power, battery life, and sensor ranges.
To Next Page