Need help?Do you have a question about the Brauniger IQ Series and is the answer not in the manual?
Discusses storing settings for different gliders and paragliders.
Details the initial display test and information shown upon power-on.
Explains the two altimeters (A1, A2) and their display modes.
Describes the analogue vario display and time constants.
Covers digital vario display and averaging vario modes.
Explains speed measurement via flywheel sensor.
Details the TEC circuit for compensating speed changes.
Covers sound settings and the stall alarm function.
Explains how to set the correct date and time.
Explains flight storage, access, and flight list printing.
Details printer compatibility and barograph recording.
Covers inserting markers and deleting recorded flights.
Explains barogram output and setting the pilot's name.
Provides details on the IQ Series battery system.
Explains the different modes for the Net Vario function.
Guides on entering minimal sink rate and upper speed range points.
Details how to conduct flights for recording polar data.
Explains using nominal speed for optimized flight path.
Describes the McCready function for climb rate optimization.
Explains McCready ring adjustments and practical examples.
Differentiates McCready glide sounds from standard vario acoustics.
Details connecting to a PC for flight data analysis.
Explains the definition and display of lift/drag ratio.
Covers connecting to GPS receivers and NMEA interface.
Describes using GPS data for target approach calculations.
Explains target height calculation and security height adjustments.
Details the required format for naming route points in GPS.
Explains using GPS data when no air speed sensor is connected.
Lists minor adjustments and software update options.
Describes how to print device settings and attach the instrument.
Advises on handling water landings and warranty information.
Details observer checks before the flight.
Covers landing procedures and barogram print-out verification.
Explains accessing Set Mode and configuring QNH, scan rate, etc.
Details settings for vario modes, time, date, and year.
Covers McCready switchover time, printer selection, and temperature units.
Details speed adaption, altitude units, and set 1/2 choice.
Introduces automatic average climb rate calculation for McCready.
Provides a visual guide to the device's buttons and displays.
To Next Page
General
