ECopyright Bravilor Bonamat B.V.
MATIC / THA
The programming of the Matic is divided in two
levels:
1. Quantity of water (included in the user
instructions)
2. Other options
WARNING
n The lower hot plate will become hot during
programming.
Level 1
P1 Quantity of water adjustment
Level 2
P2 Maximum number of cups
P3 Default on display
P4 Masking quantities
P5 Drip time
P6 Display options during brewcycle
P7 Total amount
Access level 1
P1 Adjusting the quantity of water (per cup)
You can adjust the quantity of hot water used to
brew the coffee. This is set to a standard amount
when the machine leaves the factory. If you think the
factory setting is supplying too much or too little wa-
ter, you can change the amount as follows:
1. Press the and the
1
/
0
keys at the same time
and keep them pressed in until P1 appears in
the display (after about 10 seconds).
2. Release the keys. The display will now show the
setting for the current quantity of water. This
quantity varies from machine to machine, see
table 1 .
3. Press the key for more water or the
1
/
0
key for
less.
4. The settings available range from 0, 2, 4, 6... to
98. Two steps higher will give you 3 to 5 ml.
extra water in the decanter, see table 1 .
5. Wait for about 20 seconds.
During programming
+
1
/
0
1
/
0
both Next option
Keys Display Remark
12
1
/
0
Press both keys
P1 Release keys
28
1
0
u
34
Wait 20 sec.
12 Ready to brew
The machine is now ready for use again.
To Next Page
Need help?
General
