What to do if the display panel indicator light is not working on my Bravo EV EVT- 4000e?
If the display panel indicator light isn't working or there's no starting beep when you turn the switch to the “ON” position, it could be due to a blown fuse. Remove the fuse and replace it. Also, check if the battery has very little energy left and recharge it.
What does it mean when the OH indicator is blinking on my Bravo EV Scooter?
A blinking OH indicator suggests the controller is overheating. Switch the power to the “OFF” position and wait several minutes before restarting.
What to do if the third green light is blinking while driving my Bravo EV EVT- 4000e Scooter?
If the third green light is blinking while driving, it indicates an over current issue. Turn the power to the “OFF” position and wait a few seconds before restarting.
What does it mean when the first red light is blinking on Bravo EV Scooter?
If the first red light is blinking, it means there's very little energy left. Recharge the battery immediately. It could also indicate that the battery is old or no longer working, in which case, replace the battery.
What to do if the fourth green light is blinking on my Bravo EV Scooter?
If the fourth green light is blinking, switch the power to the “OFF” position, and wait for a few seconds to restart. This issue may occur if you twist the throttle to pull away before the panel indicator stops blinking or the starting beep sound stops.
What does the second yellow light blinking mean on my Bravo EV EVT- 4000e?
If the second yellow light is blinking, it indicates insufficient energy left. Recharge the battery. If this happens while driving, switch the power to the “OFF” position and wait several minutes before restarting. You may still be able to drive a short distance.
Why Bravo EV Scooter display panel light is working but there is no movement when twisting the throttle?
If the display panel indicator light is working, but the scooter doesn't move when you twist the throttle, release the brake and then gently twist the throttle.
Why is the charging indicator not lit on my Bravo EV Scooter?
If the charging indicator is not lit, check if the outlet and inlet are securely plugged in. Try pulling them out and inserting them again, or try a different outlet.
Steps to replace the key switch, involving front cover, fender, glove box, and connector release.
Steps for checking and replacing the brake fluid and reservoir, and releasing brake hose.
Steps for front fork maintenance, including screw, fender, glove box, handle, wheel, and caliper release.
Steps to replace the front brake hose, involving handle cover, reservoir, and wheel brake hose screw release.
Steps to replace the rear brake hose, involving handle cover, reservoir, rear wheel brake hose, and various covers.
Steps to replace the front caliper, including handle cover, caliper screw, and pad release.
Steps to replace the controller, involving trim release, connectors, throttle cable, and screws.
Steps to replace the motor, involving connector, band, cover screws, nuts, and rear caliper removal.
To Next Page
General