TRIAD SERIES 3-PIECE BALL VALVE
Installation, Operation, and Maintenance Manual
of © BRAY INTERNATIONAL INC ALL RIGHTS RESERVED BRAYCOM The Information
contained herein shall not be copied transferred conveyed or displayed in any manner that would
violate its proprietary nature without the express written permission of Bray International Inc
Inspection as a minimum shall include reviewing the following
Packaging
Flange covers
Dryness
Cleanliness
These are general guidelines for valve storage Please consult the
factory for information regarding specific requirements
CAUTION
Do not stack the products on top of each other
General Storage Requirements
Manually actuated valves may be stored in the vertical or
horizontal position For air or hydraulically actuated valves
the preferred orientation is with the valve stem in the vertical
position Access ports should be secured to prevent unauthorized
entry and prevent contamination
The preferred storage location is a closed clean and dry
environment Do not expose the product to temperature
extremes
NOTICE
The preferred temperature range is F (C) to F (C)
For long-term storage in temperatures lower or higher than
the preferred range please consult the factory for information
regarding specific requirements
End protectors shall remain on the valve ends to prevent the
entrance of dirt debris or insectswildlife
Product shall remain in the original shipping container with the
original packaging materials
Valves and equipment containing elastomers including O-rings
must be stored in a climate-controlled warehouse according to
SAE-ARPD requiring
The ambient relative humidity to be less than
No exposure from direct ultraviolet or sunlight
Protection from ozone generating equipment or combustible
gases and vapors
Storage at temperatures below F (C) away from
direct sources of heat
No exposure to ionizing radiation
To Next Page
Loading...
