TRIAD SERIES 3-PIECE BALL VALVE
Installation, Operation, and Maintenance Manual
of © BRAY INTERNATIONAL INC ALL RIGHTS RESERVED BRAYCOM The Information
contained herein shall not be copied transferred conveyed or displayed in any manner that would
violate its proprietary nature without the express written permission of Bray International Inc
Service and Repair
To avoid possible injury to personnel or damage to products
safety terms must be strictly adhered to Modifying this product
substituting non-factory parts or using maintenance procedures
other than those outlined in these Installation Operation and
Maintenance instructions could drastically aect performance be
hazardous to personnel and equipment and may void existing
warranties
Apart from the operating instructions and the obligatory accident
prevention directives valid in the country of use all recognized
regulations for safety and good engineering practices must be
followed
Hazard-Free Use
NOTICE
Failure to follow these procedures could aect product
warranty
This device left the factory in proper condition to be safely
installed and operated in a hazard-free manner The notes and
warnings in this document must be observed by the user if this
safe condition is to be maintained and hazard-free operation of
the device assured
Take all necessary precautions to prevent damage to the valve
due to rough handling impact or improper storage Do not use
abrasive compounds to clean the valve or scrape metal surfaces
with any objects
The control systems in which the valve is installed must have
proper safeguards — to prevent injury to personnel or damage to
equipment — should failure of system components occur
The upper limits of permitted pressure and temperature
(depending on the housing and liner materials) must be
observed These limits are shown on the valve identification tag
The valve must not be operated until the following documents
have been observed
Declaration on EU Directives
IOM Manual (supplied with the product)
To Next Page
Loading...
