BRAYER BR1078 - Page 7

7
EN
• Do not repair the unit by yourself. Do not disassemble
the unit by yourself, if any malfunction is detected, and
after it was dropped, unplug the unit and apply to the
service center.
• Transport the kettle in the original package.
• Keep the unit out of reach of children and disabled
persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL
OR LABORATORY PURPOSES.
BEFORE USING THE KETTLE
After unit transportation or storage at low
temperature, it is necessary to keep it for at least
three hours at room temperature.
• Unpack the kettle and remove all packing materials and
advertising stickers.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the kettle for damages, in case of damage do
not plug it into the mains.
• Make sure that the specications of power supply
voltage specied on the lower panel of the unit or
the base correspond to the specications of your
mains. When using the kettle in the mains with 60
Hz frequency, the unit does not need any additional
settings.
• Wipe the outer and inner surface of the ask (1) with a
slightly damp cloth then wipe dry. Do not use abrasives
and coarse scourers for this purpose.
• Place the base (7) on a solid steady at and non-slip
non-metal surface away from heat sources as far as
possible from the edge of the surface.
• Do not place and do not use the kettle in closed space,
for example, in the cupboard or in closed structures —
this can lead to its breakage, cause harm to the user or
damage to his/her property.
• Before connecting the kettle, make sure that there are no
moisture drops on the base (7), the ask (1), the power
cord and the power plug.
Note: on the inner part of the base (7) there is a power cord
storage (8). Select the optimal length of the power cord
laying it in a corresponding way.
• Press the button (5) to open the cover (4).
• Fill the kettle with water up to the «MAX» mark,
according to the scale located on the inner surface of the
ask (1) (pic. 1).
• Close the lid (4) and make sure that the lid (4) is tightly
closed.
• Place the kettle on the base (7).
• Insert the power cord plug into the mains socket, you
will hear a sound signal, the illumination (11) will light up
white, the symbol «С» will light up, the digital symbols
(12) will display the water temperature in the kettle ask
(1).
• Press and hold the on/o󰀨 button (10) «
» (pic. 1), you
will hear a sound signal, the illumination (11) will light up
red, the digital symbols (12) will display the water heating