BRAYER BR1078 - Using the Electric Kettle

8
EN
temperature «100», after that the process of water
heating in the kettle ask (1) will be displayed with the
digital symbols (12) and the illumination (11), when
the water temperature reaches 100 ° C, you will hear
sound signals, the heating element of the kettle will be
switched o󰀨, the kettle will pass into standby mode.
• Remove the kettle from the base (7) and carefully pour
out boiled water into a suitable bowl (pic. 3).
• Remember that there is boiling water inside the kettle
ask (1), always hold the kettle only by the handle (6),
do not tilt the kettle sharply, in case of careless use of
the kettle you can get burns by hot water.
• Repeat the water boiling procedure several times.
ATTENTION! To avoid burns by hot steam, do not bend
over the spout (3).
• Hot water resulting from the rst boilings is not
recommended to consume, you may use it for domestic
needs.
USING THE ELECTRIC KETTLE
• Place the kettle on a solid steady at and non-slip
non-metal surface away from heat sources as far as
possible from the edge of the surface.
WATER BOILING
• Take the handle (5), pull it upwards and remove the lid
(4).
• Fill the kettle with water not lower than the «MIN» mark
and not higher than the «MAX» mark on the scale
located on the inner surface of the ask (1).
• Close the lid (4) and place the kettle lled with water on
the kettle stand (7).
Note: always make sure that water drops do not fall on the
contact unit of the kettle stand (7).
• Insert the power cord plug into the mains socket, you
will hear a sound signal, the illumination (11) will light up
white, the symbol «С» will light up, the digital symbols
(12) will display the water temperature in the kettle ask
(1).
• Press and hold the on/o󰀨 button (10) «
» (pic. 1), you
will hear a sound signal, the illumination (11) will light up
red, the digital symbols (12) will display the water heating
temperature, when the water temperature reaches
100°C, you will hear sound signals, the heating element
of the kettle will be switched o󰀨, the kettle will pass into
standby mode.
Note: the digital values of the water temperature depend on
the volume of water in the kettle ask (1), especially at the
minimum water level, and may be slightly di󰀨erent from the
readings when measuring the water temperature with other
measuring units.
As the water in the kettle ask (1) is heated, the illumination
color changes (11):
- when the water temperature is from 0 to 49 °С, the
illumination lights up green;
- when the water temperature is from 50 to 59 °С, the
illumination color changes to dark green;
- when the water temperature is from 60 to 69 °С, the
illumination color changes to blue;